B: Flywheel/Flywheel Hub < TC-SST >/Flywheel Bolts Installation

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Remove the engine oil and deposits from the flywheel bolt threads, crankshaft tapped hole, and flywheel.
Install the flywheel and flywheel hub < TC-SST > to the crankshaft.
Use special tool MB991883 to secure the flywheel assembly in the same manner as removal.

Fig 1: Identifying Cylinder Block And Special Tool MB991883
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Apply a small amount of engine oil to the bearing surfaces of flywheel bolts and crankshaft tapped hole, and apply the sealant to the bolt threads of flywheel.
Specified sealant: Three bond 1324 or equivalent

Fig 2: Identifying Bolt Threads
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Tighten flywheel bolts to temporary torque 40 N.m (30 ft-lb) in the order shown in the illustration.
Tighten flywheel bolts to specified torque in the order shown in the illustration.
Tightening torque: 130 N.m (96 ft-lb)

Fig 3: Identifying Flywheel Bolts Tighten Sequence
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.