LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Mechanical - Lancer Evolution) >> Camshaft >> D: Thrust Camshaft Bearing Cap/Camshaft Bearing Cap/Oil Feeding Camshaft Bearing Cap/Camshaft >> Bearing Installation >> G: Rocker Cover Assembly Installation

G: Rocker Cover Assembly Installation

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Wipe off the sealant on the mating surface of the rocker cover assembly and the cylinder head and timing chain case assembly, and degrease the surface where the sealant is applied by white gasoline or the like.
  2. Apply sealant to the joint between the cylinder head and timing chain case assembly as shown in the figure and install the rocker cover assembly to the cylinder head.

    Specified sealant: Three bond 1217G or equivalent 

    NOTE: Install the rocker cover assembly within 3 minutes after the application of sealant.
    Fig 1: Identifying Timing Chain Case Assembly
    G05392408Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Tighten the rocker cover assembly mounting bolts to the specified torque in the order of number shown in the figure.

    Tightening torque: 3.0 ± 1.0 N.m (27 ± 8 in-lb) 

  4. Tighten again the rocker cover assembly mounting bolts to the specified torque in the order of number shown in the figure.

    Tightening torque: 5.5 ± 0.5 N.m (49 ± 4 in-lb) 

    Fig 2: Identifying Rocker Cover Assembly Mounting Bolts Tighten Sequence
    G05374140Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals