How To Diagnose The Can Bus Line

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Required Special Tools:

MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: Vehicle Communication Interface (V.C.I.)
- MB991827: M.U.T.-III USB Cable
- MB991910: M.U.T.-III Main Harness A

CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.

Connect scan tool MB991958 to the data link connector.
Turn the ignition switch to the "ON" position.
Select "CAN bus diagnosis" from the start-up screen.
When the vehicle information is displayed, confirm that it matches the vehicle whose CAN bus lines will be diagnosed.
- If they match, go to step 8.
- If not, go to step 5.
  
  Fig 1: Connecting Special Tool To Data Link Connector
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Select "view vehicle information" button.
When the vehicle information is displayed, confirm again that it matches the vehicle which is diagnosed CAN bus line.
- If they match, go to step 8.
- If not, go to step 5.
Press the "OK" button.
When the options are displayed, choose the options (mark the check) and then select "OK".