<< C >> Driver's Air Bag Module Removal

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Never use an electric tester to diagnose the air bag module circuit. Never attempt to disassemble the air bag module.
Store the removed air bag module in a clean, dry place with the pad surface facing upward.
When discarding the air bag module, deploy the air bag as specified in the service procedure. (Refer to AIR BAG MODULE DISPOSAL PROCEDURE .)
With the driver's air bag module mounting torx screw, loosen the screw, but do not remove it.

Using the torx wrench (T30), remove the driver's air bag module.

Fig 1: Removing Driver's Air Bag Module

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.