<< B >> Self-Lock Nut (Tie-Rod End And Knuckle Connection) Removal

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Loosen the self-locking nut (tie-rod end connection) from the ball joint, but do not remove here. Use the special tool.
To prevent the special tool from dropping off, suspend it with a rope.

Install special tool MB991897 or MB992011 as shown in the figure.

Fig 1: Identifying Special Tool MB991897 Or MB992011
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Turn the bolt and knob to make the special tool jaws parallel, then hand-tighten the bolt. After tightening, check that the jaws are still parallel.
NOTE: To adjust the special tool jaws to be parallel, set the orientation of the knob as shown in the figure.

Fig 2: Turning Bolt And Knob
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Unscrew the bolt to disconnect the ball joint.