LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Steering -- Lancer Evolution) >> Power Steering Gear Box And Linkage >> Disassembly And Reassembly >> Assembly Service Point >> >> B << Tie-Rod End/Locking Nut Installation

>> B << Tie-Rod End/Locking Nut Installation

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Screw in the tie-rod to the length shown in the figure, and hand-tighten the locking nut.

NOTE: Install the steering gear and linkage to the body, adjust the toe-in, and then tighten the locking nut to the specified torque.
Fig 1: Measuring Length Of Tie Rod
G05394775Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals