<< A >> Side Air Dam Removal

Gently lift and remove the side air dam. If there is any double-sided tape remaining on the side air dam, remove according to the following instructions.

1. Remove double-sided tape remaining on the body surface (when replacing side air dam).
   1. Attach protection tape all the way along the edges of the double-sided tape which is still adhering to the body.
      Fig 1: Identifying Protection Tape And Double-Sided Tape Applying Points

      Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
   2. Scrape off the double-sided tape with a resin spatula as possible.
   Fig 2: Scraping Off Double-Sided Tape
   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
   3. Peel off the protection tape.
   4. Use a shop towel moistened with 3M™ AAD Part number 8906 or equivalent to wipe the body.
2. Remove double-sided tape remaining on side air dam and adhere double-sided tape (when re-using side air dam).
   1. Scrape off the double-sided tape on the side air dam with a resin spatula as much as possible.
   2. Wipe the side air dam surface and clean it with a rag moistened with isopropyl alcohol.
   Fig 3: Wiping Side Air Dam Surface
   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
   3. Remove only a small amount of the residual adhesive.
   4. Apply the primer as specified on the residual adhesive.
   5. Adhere the double-sided tape as specified on the side air dam.