LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Exterior - Lancer Evolution) >> Side Air Dam >> Removal And Installation >> Installation Service Point >> >> A << Side Air Dam Installation

>> A << Side Air Dam Installation

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Tear off the double-sided tape backing paper.
    NOTE: Attach the adhesive tape to the edge of the backing paper makes the backing paper tear off easier.
    Fig 1: Tearing Off Double-Sided Tape Backing Paper
    G05384525Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Install the side air dam.
    NOTE: If the double-sided tape is difficult to affix in cold temperature, etc., warm the bonding surfaces of the body and side air dam to about 40 - 60°C (104 - 140°F) before affixing the tape.
  3. Firmly press in the side air dam.
scientia non olet · About LEMON Manuals