>> A << Tape Installation

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Installation position
CAUTION:
- The ambient temperature should be 15 (59) to 40°C(104°F). Ensure that the working area is clean.
- If ambient temperature is less than 15°C (59°F), heat the tape and application surface to a temperature of 15 (59) to 40°C (104°F).
- Be careful that air bubbles are not formed under the tape.
Installation procedure

Fig 1: Identifying Rear Spoller Assembly
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
1. Wipe the tape application surface and clean it with a rag moistened with isopropyl alcohol.
2. Remove backing paper from the tape, and apply it to the rear spoiler assembly.