>> A << Mark Installation

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

2. Front step plate

Fig 1: Identifying Front Step Plate Mark Dimension

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

3. Rear three-diamond mark

Fig 2: Identifying Rear Three-Diamond Mark Dimension

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

4. MITSUBISHI mark

Fig 3: Identifying Mitsubishi Mark Dimension

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

5. LANCER EVOLUTION mark

Fig 4: Identifying Lancer Evolution Mark Dimension

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Installation position
Attach each mark to the position shown in the illustration.
Installation procedure
1. Use 3M™ AAD Part number 8906 or equivalent to clean the mark installation surfaces on the body.
  CAUTION: When attaching the marks, the ambient temperature should be 20 - 38°C (68 - 100°F) and the air should be completely free of dust. If the ambient temperature is lower than 20°C (60°F), the marks and the places on the vehicle body where the marks are to be attached should be heated to 20 - 30°C (68 - 86°F).
2. Peel off the protection sheet on the back of the marks to affix it in position.