How To Read And Erase Diagnostic Trouble Codes

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Required Special Tools:

MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: Vehicles Communication Interface (V.C.I).
- MB991827: M.U.T.-III USB Cable
- MB991910: M.U.T.-III Main Harness A (Vehicles with CAN communication system)
  NOTE: If the battery voltage is low, diagnostic trouble codes will not be set. Check the battery if scan tool MB991958 does not display.

Connect scan tool MB991958 to the data link connector.
Turn the ignition switch to the "ON" position.
Select "System select" from the start-up screen.
Select "From 2006 MY" of "Model Year." When the "Vehicle Information" is displayed, check the contents.
Select "Meter" from "System List," and press the "OK" button.
NOTE: When the "Loading Option Setup" list is displayed, check the applicable item.
Select "Diagnostic Trouble Code".
If a DTC is set, it is shown.
Choose "Erase DTCs" to erase the DTC.