LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Chassis Electrical - Lancer Evolution (1 Of 5)) >> Headlight >> On-Vehicle Service >> Replace The Bulb >> Headlight Bulb (Low-Beam) Replacement < Vehicles Without Discharge Headlight >

Headlight Bulb (Low-Beam) Replacement < Vehicles Without Discharge Headlight >

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Do not touch the bulb surface with bare hands or dirty gloves. If the bulb surface (glass part) gets dirty, immediately clean it with alcohol or thinner. After drying completely, install the bulb.
  1. When replacing the right bulb, lift the radiator condenser tank upward, and remove it. When replacing the left bulb, remove the relay box.
    Fig 1: Identifying Radiator Condenser Tank
    G05396824Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 2: Relay Box With Torque Specifications
    G05396825Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Disconnect the connector, and twist the headlight bulb (low-beam) to remove.
    Fig 3: Locating Headlight Bulb
    G05385314Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals