LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Lubrication - Lancer Evolution) >> Oil Pump Chain >> Removal And Installation >> Installation Service Points >> >> A << Crankshaft Sprocket Installation

>> A << Crankshaft Sprocket Installation

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Wipe the dirt off of the crankshaft sprocket and the crankshaft using a rag, and then remove the grease from the portion shown in the illustration.
    NOTE: Remove grease to prevent a drop in the coefficient of friction of the pressing portion caused by adhesion of oil.
  2. Set the No. 1 piston at top dead center of the compression stroke.
  3. Install the crankshaft sprocket to the crankshaft.
    Fig 1: Identifying Crankshaft Sprocket Grease Points
    G05392685Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals