LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Intake And Exhaust - Lancer Evolution) >> Exhaust Manifold And Turbocharger >> Removal And Installation >> Installation Service Points >> >> E << Turbocharger Exhaust Outlet Fitting Bracket Installation

>> E << Turbocharger Exhaust Outlet Fitting Bracket Installation

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check that the turbocharger exhaust outlet fitting bracket is in close contact with the turbocharger exhaust outlet fitting and with the cylinder block, and then temporarily tighten the turbocharger exhaust outlet fitting bracket.
  2. Tighten the bolt of the cylinder block side to the specified torque.

    Tightening torque: 51 ± 7 N.m (38 ± 5 ft-lb) 

  3. Tighten the bolt of the turbocharger exhaust outlet fitting bracket side to the specified torque.

    Tightening torque: 64 ± 5 N.m (48 ± 3 ft-lb) 

    Fig 1: Removing Turbocharger Compressor Bracket Mounting Bolt (Cylinder Block Side)
    G05393680Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals