LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical <2.0L Non-Turbo> - Lancer >> Valve Stem Seal >> Removal And Installation >> Installation Service Points >> >>F<< Front Camshaft Bearing Cap Installation

>>F<< Front Camshaft Bearing Cap Installation

CAUTION: When the mounting bolts are tightened with the front camshaft bearing cap tilted, the front camshaft bearing cap is damaged. Install the front camshaft bearing cap properly to the cylinder head and camshaft.
  1. Install the front camshaft bearing cap to the cylinder head, and temporarily tighten the front camshaft bearing cap mounting bolts to the specified torque in the order of the figure (1.)

    Tightening torque: 17 ± 3 N.m (13 ± 2 ft-lb) 

  2. Tighten the front camshaft bearing cap mounting bolts again to the specified torque in the order of the figure (2.)

    Tightening torque: 30 ± 2 N.m (23 ± 1 ft-lb) 

    Fig 1: Identifying Front Camshaft Bearing Cap
    G06670873Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals