LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical <2.0L Non-Turbo> - Lancer >> Engine Assembly >> Removal And Installation >> Installation Service Points >> >>D<< Fuel High-Pressure Hose Connection

>>D<< Fuel High-Pressure Hose Connection

CAUTION: After connecting the fuel high-pressure hose, slightly pull it in the pull-out direction to check that it is installed firmly. In addition, check that there is approximately 3 mm (0.12 inch) play. After the check, install the stopper securely.

Apply a small amount of engine oil to the fuel line pipe, and install the fuel high-pressure hose.

Fig 1: Installing Fuel High-Pressure Hose
G06670943Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Fig 2: Identifying Stopper
G06670944Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals