LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical <2.0L Non-Turbo> - Lancer >> Camshaft >> Removal And Installation >> Installation Service Points >> >>B<< Camshaft/Camshaft Sprocket Installation

>>B<< Camshaft/Camshaft Sprocket Installation

  1. Use a monkey wrench to secure the hexagon part of the camshaft in the same manner as removal.
    Fig 1: Securing Hexagon Part Of Camshaft
    G06670847Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Apply an adequate and minimum amount of engine oil to the camshaft and camshaft sprocket as shown in the illustration.
  3. Install the camshaft sprocket to the camshaft.
  4. Apply an adequate and minimum amount of engine oil to the camshaft sprocket mounting bolt.
  5. Tighten the camshaft sprocket mounting bolt to the specified torque.

    Tightening torque: 59 ± 5 N.m (44 ± 3 ft-lb) 

    Fig 2: Identifying Engine Oil Applying Area To Camshaft And Camshaft Sprocket
    G06670848Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals