LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Intake System And Exhaust System - Lancer >> EXHAUST PIPE, MAIN MUFFLER AND CATALYTIC CONVERTER (2.0L ENGINE Turbo) >> Removal And Installation >> Installation Service Points >> >>B<< Heated Oxygen Sensor Installation

>>B<< Heated Oxygen Sensor Installation

Tighten the heated oxygen sensor to the specified torque by using special tool MB991953.

Tightening torque: 44 ± 5 N.m (33 ± 3 ft-lb) 

Fig 1: Installing Heated Oxygen Sensor
G06671840Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals