LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Intake System And Exhaust System - Lancer >> CHARGE AIR COOLER (2.0L ENGINE Turbo) >> Removal And Installation >> Installation Service Point >> >>A<< Air Hose/Air Pipe Installation

>>A<< Air Hose/Air Pipe Installation

  1. Insert hose to stopper end and not overlap with stopper.
  2. Place the hose clamp as shown in the illustration so that it does not overlap with the bulge and the stopper end. Then, set the hose clamp 5 ± 1 mm (0.20 ± 0.04 inch) away from the stopper.
    Fig 1: Identifying Distance Between Bulge And Stopper End
    G06671816Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    CAUTION: Do not use an electric screwdriver or air tool. Manually tighten the hose clamp.
  3. Align the mating marks on the air hose, air pipe, and hose clamp. Then, tighten the hose clamp to the specified torque.

    Tightening torque: 6.0 ± 1.0 N.m (54 ± 8 in-lb) 

    Fig 2: Aligning Mating Marks On Air Hose, Air Pipe, And Hose Clamp
    G06671817Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals