Hub Bolt Replacement

Required Special Tools: 

• MB990767: Front Hub and Flange Yoke Holder
• MB991618: Hub Bolt Remover

1. Remove the caliper assembly and brake disc, and retain the caliper assembly with a wire and the like to prevent from falling (Refer to FRONT AXLE HUB ASSEMBLY  ).
2. Use special tool MB991618 to remove the hub bolts.
   Fig 1: Removing Hub Bolts Using Special Tool MB991618

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
3. Install the plain washer to the new hub bolt, and install the bolt with a nut while holding the hub with special tool MB990767.
4. Install the brake disc and the caliper assembly (Refer to FRONT AXLE HUB ASSEMBLY  ).
   Fig 2: Installing Plain Washer To Hub Bolt

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.