LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> Front Axle -- Lancer >> Front Axle Hub Assembly >> Disassembly And Assembly >> Assembly Service Points >> >>D<< Wheel Bearing End Play Check

>>D<< Wheel Bearing End Play Check

  1. Use special tools MB991000 and MB991017 to measure to determine whether the wheel bearing end play is within the specified limit or not.

    Limit: 0.05 mm(0.002 inch) 

  2. If the end play is not within the limit range while the nut is tightened to the specified torque, the bearing, hub and/or knuckle have probably not been installed correctly. Replace the bearing and re-install.

    Tightening torque: 144 - 176 N.m (107 - 129 ft-lb) 

    Fig 1: Measuring Wheel Bearing End Play
    G06672534Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals