>>B<< LJ Assembly Installation

Apply a thin coat of the specified grease to the ball grooves of the inner and outer races.
Specified grease: Repair kit grease
Assemble the LJ assembly outer race, cage, balls, and inner race with their mating marks aligned.

Fig 1: Identifying LJ Assembly Outer Race, Cage, And Inner Race
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Apply specified grease to the LJ assembly.
Specified grease: Repair kit grease

Amount to use: 75 ± 5 g (2.6 ± 0.1 ounces)

Fig 2: Applying Grease To LJ Assembly
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Apply a little of the specified adhesive to the surface which has groove (for packing) of LJ assembly (shown by arrows in the illustration), fix the rubber packing.
Specified adhesive: 3M™ AAD Part No. 8730, 8731 or equivalent
Set the groove side of LJ assembly (for packing) toward the LJ boot side and install them.

Fig 3: Locating Adhesive Applying Area On LJ Assembly Surface
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Align the mating marks of LJ assembly and rear propeller shaft, then install the LJ assembly to rear propeller shaft using socket wrench.

Fig 4: Installing LJ Assembly To Rear Propeller Shaft Using Socket Wrench
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Using the bolt, align the bolt holes of the LJ boot and the LJ assembly and install LJ boot to the LJ assembly.

Fig 5: Identifying LJ Boot And Bolt
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Install the rubber packing of the companion flange side in the same manner as described in (4) above.