LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Hood -- Lancer >> On-Vehicle Service >> Alignment Of Hood Latch And Striker

Alignment Of Hood Latch And Striker

  1. Remove the headlight support panel cover (Refer to FRONT BUMPER ASSEMBLY AND RADIATOR GRILLE -- LANCER Front Bumper Assembly and Radiator Grille ).
  2. Loosen the hood latch mounting bolts but do not remove them. Move the hood latch up/down and left/right to align the hood level and adjust the hood striker engagement.
  3. After the adjustment, tighten the hood latch mounting bolts to 9.0 ± 1.0 N.m (80 ± 9 in-lb).
  4. Install the headlight support panel cover. (Refer to FRONT BUMPER ASSEMBLY AND RADIATOR GRILLE -- LANCER , Front Bumper Assembly and Radiator Grille .)
    Fig 1: Locating Hood Latch Mounting Bolts
    G06673053Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals