LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine Overhaul <2.0L Non-Turbo> - Lancer >> Throttle Body And EGR System >> Removal And Installation >> Installation Service Points >> >>D<< Throttle Body Gasket/Throttle Body Installation

>>D<< Throttle Body Gasket/Throttle Body Installation

  1. Make sure that the throttle body gasket is placed before installing the throttle body.
  2. Temporarily tighten throttle body and throttle body stay mounting bolts at A and B in the illustration.
  3. Tighten the throttle body mounting bolt at illustrated position A to the specified torque of 20 ± 2 N.m (15 ± 1 ft-lb).
  4. Tighten the throttle body mounting bolts at illustrated position B to the specified torque of 9.5 ± 2.5 N.m (84 ± 22 in-lb).
    Fig 1: Identifying Throttle Body Bolts
    G06670973Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals