LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine Overhaul <2.0L Non-Turbo> - Lancer >> Oil Pump Chain >> Removal And Installation >> Installation Service Points >> >>D<< Rear Oil Seal Installation

>>D<< Rear Oil Seal Installation

CAUTION: Do not apply oil to the circumference of the oil seal and oil seal pressing hole on the cylinder block side to prevent teeth from pulling out.

After applying a small amount of engine oil to the oil seal lip, use special tool MD998718 to press fit the oil seal.

Fig 1: Applying Small Amount Of Engine Oil To Oil Seal Lip
G06671071Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals