LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine Overhaul <2.0L Non-Turbo> - Lancer >> Oil Pump Chain >> Removal And Installation >> Installation Service Points >> >>B<< Crankshaft Sprocket Installation

>>B<< Crankshaft Sprocket Installation

  1. Wipe off the dirt on the crankshaft sprocket and the crankshaft using a rag, and then remove the grease from the portion shown in the illustration.
    NOTE: Remove grease to prevent a drop in the coefficient of friction of the pressing portion caused by adhesion of oil.
  2. Set the Number 1 piston at top dead center on the compression stroke.
  3. Install the crankshaft sprocket to the crankshaft.
    Fig 1: Identifying Crankshaft Sprocket Installation Position
    G06671069Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals