LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine Overhaul <2.0L Non-Turbo> - Lancer >> Exhaust Manifold >> Removal And Installation >> Installation Service Points >> >>B<< Exhaust Manifold Bracket A/Exhaust Manifold Bracket B Installation

>>B<< Exhaust Manifold Bracket A/Exhaust Manifold Bracket B Installation

CAUTION: The exhaust manifold gasket, washers and nuts must not be reused.

Make sure that exhaust manifold bracket A is in intimate contact with exhaust manifold and cylinder block, and then tighten it to the specified tightening torque.

Specified torque: 41 ± 10 N.m (30 ± 7 ft-lb) 

Fig 1: Identifying Exhaust Manifold Bracket A
G06670984Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals