LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine Mechanical <2.0L Non-Turbo> - Lancer >> Oil Pan >> Removal And Installation >> Installation Service Points >> >>A<< Engine Oil Pan Installation

>>A<< Engine Oil Pan Installation

  1. Remove all the traces of sealant adhering to the engine oil pan and cylinder block assembly using a remover or others. Then, degrease them.
  2. Apply the sealant without any gap to the mating surface of engine oil pan as shown in the illustration. Install the engine oil pan to the cylinder block assembly.

    Specified sealant: Three bond 1217G or equivalent 

    NOTE: Install the engine oil pan immediately after applying sealant.
    CAUTION: After the installation, until a sufficient period of time (one hour or more) elapses, do not apply the oil or water to the sealant application area or start the engine.
  3. Tighten the engine oil pan mounting bolts to the specified torque.

    Tightening torque: 

    M6: 10 ± 2 N.m (89 ± 17 in-lb) 

    M8: 29 ± 2 N.m (22 ± 1 ft-lb) 

    Fig 1: Identifying Sealant Applying Area
    G06670878Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals