LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Engine Intake System And Exhaust System - Lancer >> EXHAUST MANIFOLD (2.0L ENGINE Non-turbo, 2.4L ENGINE) >> Removal And Installation >> Installation Service Point >> >>A<< Exhaust Manifold Cover (Lower)/Exhaust Manifold/Exhaust Manifold Washer/Exhaust Manifold Nut Installation

>>A<< Exhaust Manifold Cover (Lower)/Exhaust Manifold/Exhaust Manifold Washer/Exhaust Manifold Nut Installation

  1. Install the exhaust manifold cover (lower) to the exhaust manifold (with mounting bolts removed), install the exhaust manifold and the exhaust manifold cover (lower) to the engine as a set.
  2. Move the exhaust manifold cover (lower) to the position where it will not interfere with the installation of the exhaust manifold nut.
  3. Install the new exhaust manifold nuts and exhaust manifold washers, and tighten the exhaust manifold nuts to the specified torque.

    Tightening torque: 49 ± 5 N.m (36 ± 4 ft-lb) 

  4. Install the exhaust manifold cover (lower) to the exhaust manifold, and tighten the exhaust manifold cover (lower) mounting bolts to the specified torque.

    Tightening torque: 

    14 ± 1 N.m (120 ± 13 in-lb) <Except vehicles for California> 

    8.0 ± 2.0 N.m (71 ± 18 in-lb) <Vehicles for California> 

scientia non olet · About LEMON Manuals