LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling -- Lancer >> On-Vehicle Service >> Cooling Fan Motor Check (2.0L Engine Turbo)

Cooling Fan Motor Check (2.0L Engine Turbo)

  1. Disconnect the fan motor connector.
    Fig 1: Identifying Radiator Fan Motor Connector And Condenser Fan Motor Connector
    G06671759Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Check that the fan motor runs when a positive battery terminal is connected to the fan motor-side connector terminal number 1, and terminal number 2 is grounded. Also check to see that there is no abnormal sound emitted from the fan motor at this time.
  3. If the fan motor is defective, replace it (Refer to <<B>> FAN, FAN MOTOR AND COOLING FAN SHROUD ASSEMBLY REMOVAL  .)
  4. Connect the fan motor connector.
    Fig 2: Locating Condenser Fan Motor Connector
    G06671760Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 3: Locating Radiator Fan Motor Connector
    G06671761Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals