Section 8 (MULTIPORT Fuel Injection (MFI) (3.8L) - General Description, Introduction, Diagnostic Trouble Code & Symptom Charts)
WARNING: This page is about a different variant/trim than selected.
- General Description
- MULTIPORT Fuel Injection (MFI) Diagnosis
- Troubleshooting Strategy
- Diagnostic Function
- Malfunction Indicator Lamp (Service Engine Soon Or Check Engine Lamp)
- How To Connect The Scan Tool (M.U.T.-III)
- How To Read And Erase Diagnostic Trouble Codes
- How To Read Data List
- How To Perform Actuator Test
- How To Diagnose The Can Bus Lines
- PROVISIONAL DTCs [OBD-II Test Mode - Results (Mode 7)]
- Mode 6 Reference Table
- Diagnostic By Diagnostic Test Mode II (Increased Sensitivity)
- On-Board Diagnostics
- OBD-II Drive Cycle
- System Readiness Test Status
- Fail-Safe Function Reference Table
- Diagnostic Trouble Code Chart
- Symptom Chart