LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Eclipse Spyder GS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle Overhaul (F4A4B)) >> UNDERDRIVE Clutch And Input Shaft >> Disassembly And Assembly >> Assembly Service Points >> >>D<< Snap Ring Installation

>>D<< Snap Ring Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the snap ring into the groove of clutch retainer.
  2. Set special tools MB991628 and MD998924 as shown in the illustration, and then compress the clutch element.
  3. Check that the clearance between the snap ring and the clutch reaction plate is within the standard value. If not within the standard value, select a snap ring so that it is.

Standard value of clearance: 

1.6 - 1.8 mm (0.063 - 0.070 inch) 

Fig 1: Installing Snap Ring Into Groove Of Clutch Retainer
G06245658Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals