>>C<< Clutch Plate/Clutch Disc/Clutch Reaction Plate Installation

WARNING: This page is about a different variant/trim than selected.

CAUTION: Immerse the clutch disc in ATF before assembling it. If the clutch disc is new, soak it in ATF for at least two hours.

Assemble the four clutch plates and four clutch discs one on top of the other inside the underdrive clutch retainer. All four clutch plates should be assembled so that the places with no teeth (marked "A") are aligned with the holes in the retainer (marked "B").

Fig 1: Aligning Clutch Plates Teeth Marked A With Marked B
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Install the clutch reaction plate in the direction shown.

Install it the same as the clutch plates, so that the areas with no teeth (marked "A") are aligned with the retainer (marked "B").

Fig 2: Installing D-Rings In Grooves On Reverse Clutch Retainer

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.