LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Eclipse Spyder GS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle Overhaul (F4A4B)) >> UNDERDRIVE Clutch And Input Shaft >> Disassembly And Assembly >> Assembly Service Points >> >>B<< Snap Ring Installation

>>B<< Snap Ring Installation

WARNING: This page is about a different variant/trim than selected.
  1. Place the snap ring on top of the spring retainer, and then set special tool MD998907 and MD998924 as shown in the illustration.
  2. Compress the return spring and install the snap ring.
Fig 1: Installing Special Tools
G04277320Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals