LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Eclipse Spyder GS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle Overhaul (F4A4B)) >> Reverse And Overdrive Clutch >> Disassembly And Assembly >> Assembly Service Points >> >>F<< Clutch Plate/Clutch Disc/Clutch Reaction Plate Installation

>>F<< Clutch Plate/Clutch Disc/Clutch Reaction Plate Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION: Immerse the clutch disc in ATF before assembling it. If the clutch disc is new, soak it in ATF for at least two hours.
  1. Assemble two clutch discs and two clutch plates, one on top of the other, inside the reverse clutch retainer. Assemble both clutch plates so that the places with no teeth (marked "A") are aligned with the holes in the retainer (marked "B").
    Fig 1: Aligning Clutch Plates Teeth Marked A With Marked B
    G04231417Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Install the clutch reaction plate in the direction shown. Install it the same as the clutch plate, so that the places with no teeth (marked "A") are aligned with the holes in the retainer (marked "B").
    Fig 2: Identifying Installing Clutch Reaction Plate Direction
    G06245669Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals