>>D<< Pressure Plate/Clutch Plate/Clutch Disc/Clutch Reaction Plate Installation

WARNING: This page is about a different variant/trim than selected.

CAUTION: Immerse the clutch disc in ATF before assembling it. If the clutch disc is new, soak it in ATF for more than two hours.

Assemble the clutch discs (four pieces) and clutch plates (four pieces), one on top of the other, inside the reverse clutch piston. Assemble both clutch plates so that the places with no teeth (marked "A") are aligned with the holes in the retainer (marked "B").

Fig 1: Aligning Clutch Plates Teeth Marked A With Marked B
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Install the clutch reaction plate in the direction shown.

Fig 2: Identifying Installing Clutch Reaction Plate Direction
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.