LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Eclipse Spyder GS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle Overhaul (F4A4B)) >> Reverse And Overdrive Clutch >> Disassembly And Assembly >> Assembly Service Points >> >>C<< Snap Ring Installation

>>C<< Snap Ring Installation

WARNING: This page is about a different variant/trim than selected.
  1. Set special tools MD999590 and MD998924 as shown in the illustration.
  2. Tighten the nut on the special tool to press down on the spring retainer and reverse clutch retainer, and then install the snap ring.
    Fig 1: Installing Special Tools
    G04277326Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Check that the clearance between the snap ring and the return spring retainer is within the standard value. If not within the standard value, select a snap ring so that it is.

    Standard value of clearance: 

    0 - 0.09 mm (0 - 0.003 inch) 

Fig 2: Checking Clearance Between Snap Ring And Return Spring Retainer
G06245664Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals