LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Eclipse Spyder GS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle Overhaul (F4A4B)) >> Output Shaft >> Disassembly And Assembly >> Assembly Service Points >> >>A<< Taper Roller Bearing Installation

>>A<< Taper Roller Bearing Installation

WARNING: This page is about a different variant/trim than selected.
  1. Set the output shaft on the press support stand.
  2. Using special tools MD998823, MD998812 and MD998814, press in the taper roller bearing.
Fig 1: Pressing Taper Roller Bearing
G06245679Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals