>>A<< Spacer/Side Gear/Washer/Pinion And Pinion Shaft Installation

WARNING: This page is about a different variant/trim than selected.

Mount a spacer on the back surface of the side gear, and then install the side gear in the differential case.
NOTE: When a new side gear is to be installed, use a medium thickness spacer [0.93 to 1.00 mm (0.037 to 0.039 inch)].
Set the washer on the back of each pinion, and put both pinions simultaneously in mesh with the side gears. While rotating them, install them into position.

Fig 1: Installing Washer On Pinion
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Insert the pinion shaft.

Fig 2: Inserting Pinion Shaft
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Measure the backlash between the side gear and pinion.
Standard value of backlash:

0.025 - 0.150 mm (0.0010 - 0.0059 inch)
If the backlash is out of the standard value, select a spacer and re-measure the backlash.
NOTE: Adjust until the backlash on both sides are equal.

Fig 3: Measuring Backlash Between Side Gear And Pinion
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.