Removal And Installation: <5A/T>

WARNING: This page is about a different variant/trim than selected.

CAUTION: *: Indicates parts which should be temporarily tightened, and then fully tightened after placing the vehicle horizontally and loading the full weight of the engine on the vehicle body.

Fig 1: Exploded View Of Transaxle Assembly With Torque Specifications

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Exploded View Of Transaxle Assembly With Torque Specifications

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Required Special Tools:

MB990242: Puller Shaft Puller
MB990244: Puller Bar
MB990767: End Yoke Holder
MB990998: Front Hub Remover and Installer
MB991000: Spacer
MB991354: Puller Body
MB991454: Engine Hanger Balancer
MB991895: Engine Hanger
MB991897: Ball Joint Remover
MB991928: Engine Hanger
MB991929: Joint (50)
MB991931: Joint (140)
MB991932: Foot (standard)
MB991934: Chain and Hook Assembly
MB992012: Engine hanger plate A
MB992013: Engine hanger plate B