LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Eclipse Spyder GS, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Basic Brake System >> Brake Pedal >> Inspection >> Stoplight Switch Check

Stoplight Switch Check

  1. Connect an ohmmeter between the stoplight switch connector terminals.
  2. There should be no continuity between the terminals when the plunger is pushed in as shown. There should be continuity when it is released.
    CONTINUITY SPECIFICATION

    TESTER CONNECTION PLUNGER SPECIFIED CONDITION
    1 - 2 IN Open circuit
    OUT Less than 2Ω
    Fig 1: Checking Stoplight Switch Connector Terminals
    G06689625Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals