Individual Component Service
WARNING:
- If heat damage occurs during paint work, remove the SRS-ECU, the air bag modules, the clock spring, front seats, impact sensor and the seat belt with pre-tensioner. Recheck the SRS system operability after reinstalling them.
- SRS-ECU, air bag module, clock spring, front seats, impact sensor: 93°C (200°F) or more
- Seat belt with pre-tensioner: 90°C (194°F) or more
- If the SRS components are removed for the purpose of inspection, sheet metal repair, painting, etc., they should be stored in a clean, dry place until they are reinstalled.
If the SRS components are to be removed or replaced as a result of maintenance, diagnosis, etc., follow the appropriate procedure in Front impact sensor (refer to FRONT IMPACT SENSORS ), SRS-ECU (refer to SRS CONTROL UNIT (SRS-ECU) ), Air bag modules and clock spring (refer to AIR BAG MODULE(S) AND CLOCK SPRING ), Side-air bag module (refer to FRONT SEAT ASSEMBLY ), Side impact sensor (refer to SIDE IMPACT SENSOR ), Curtain air bag module (refer to CURTAIN AIR BAG MODULE(S) ) and Seat belt with pre-tensioner (refer to SEAT BELTS WITH PRE-TENSIONER ).