LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2008 >> Outlander LS, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (MULTIPORT Fuel Injection (2.4L) (1 Of 6)) >> Service Specifications

Service Specifications

WARNING: This page is about a different variant/trim than selected.
SERVICE SPECIFICATIONS

ITEMS STANDARD VALUE
Fuel pressure kPa (psi) Approximately 324 (47) at curb idle
Intake air temperature sensor resistance kΩ -20°C (-4°F) 13-17
0°C (32°F) 5.3-6.7
20°C (68°F) 2.3-3.0
40°C (104°F) 1.0-1.5
60°C (140°F) 0.56-0.76
80°C (176°F) 0.30-0.45
Engine coolant temperature sensor resistance kΩ -20°C (-4°F) 14-17
0°C (32°F) 5.1-6.5
20°C (68°F) 2.1-2.7
40°C (104°F) 0.9-1.3
60°C (140°F) 0.48-0.68
80°C (176°F) 0.26-0.36
Heated oxygen sensor output voltage V 0.6-1.0
Heated oxygen sensor heater resistance Ω Front 4.5-8.0 [at 20°C (68°F)]
Rear 4.5-8.0 [at 20°C (68°F)]
Injector coil resistance Ω 10.5-13.5 [at 20°C (68°F)]
Throttle actuator control motor coil resistance Ω 0.3-80 [at 20°C (68°F)]
Intake engine oil control valve coil resistance Ω 6.9-7.9 [at 20°C (68°F)]
Exhaust engine oil control valve coil resistance Ω 6.9-7.9 [at 20°C (68°F)]