LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2008 >> Outlander LS, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (MULTIPORT Fuel Injection (2.4L) (1 Of 6)) >> General Specifications

General Specifications

WARNING: This page is about a different variant/trim than selected.
GENERAL SPECIFICATIONS

ITEMS SPECIFICATIONS
Throttle body Throttle bore mm (in.) 57 (2.24)
Throttle position sensor Hall element type
Throttle actuator control motor DC motor type, having brushes
Engine control module (ECM) Identification model No. E6T47380 < FWD >
E6T47381 < AWD >
Sensors Mass airflow sensor Heat sensitizing type
Barometric pressure sensor Semiconductor diffused pressure type
Intake air temperature sensor Thermistor type
Engine coolant temperature sensor Thermistor type
Heated oxygen sensor Zirconia type
Accelerator pedal position sensor Hall element type
Intake camshaft position sensor Magneto resistance element type
Exhaust camshaft position sensor Magneto resistance element type
Crankshaft position sensor Magneto resistance element type
Knock sensor Piezoelectric element type
Power steering pressure switch Contact switch type
Manifold absolute pressure sensor Piezo resistive semiconductor type
Fuel tank differential pressure sensor Piezo resistive semiconductor type
Fuel tank temperature sensor Thermistor type
Actuators Multiport fuel injection (MFI) relay Contact switch type
Fuel pump relay Contact switch type
Throttle actuator control motor relay Contact switch type
Starter relay Contact switch type
A/C compressor clutch relay Contact switch type
Injector relay Contact switch type
Injector type and number Electromagnetic type, 4
Injector identification mark JME290H
Intake engine oil control valve Duty cycle type solenoid valve
Exhaust engine oil control valve Duty cycle type solenoid valve
EGR valve Stepper motor type
Evaporative emission purge solenoid Duty cycle type solenoid valve
Evaporative emission ventilation solenoid ON/OFF type solenoid valve