LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2008 >> Outlander LS, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Electronic Control - 4WD) >> Drive Mode Selector >> Drive Mode Selector Check

Drive Mode Selector Check

WARNING: This page is about a different variant/trim than selected.
CONTINUITY REFERENCE CHART

Switch position Terminal number Normal conditions
FWD 1-2 Continuity exists (2 ohm or less).
2-3 No continuity
AWD 1-2 No continuity
2-3
LOCK 1-2 No continuity
2-3 Continuity exists (2 ohm or less).
Fig 1: Identifying Drive Mode Selector Connector Terminal
G05432294Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals