>>C<< Transaxle Control Cable (Transaxle Side) Installation

WARNING: This page is about a different variant/trim than selected.

Move the selector lever and manual control lever to the N position.
Use the adjusting nut to tighten the transaxle control cable to the specified torque.
Tightening torque: 9.5 ± 3.5 N.m (84 ± 31 in-lb)

Fig 1: Installing Transaxle Control Cable

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Identifying Transaxle Control Cable Connector Terminals

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.