LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2008 >> Outlander LS, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (CVT - On-Vehicle Service & Diagnosis) >> Special Tool

Special Tool

WARNING: This page is about a different variant/trim than selected.
SPECIAL TOOL REFERENCE CHART

Tool Tool number and name Supersession Application
G05431330Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 MB991955
  1. MB991824
  2. MB991827
  3. MB991910
  4. MB991911
  5. MB991825
  6. MB991826

M.U.T.-III sub-assembly
  1. Vehicle communication interface (V.C.I.)
  2. USB cable
  3. M.U.T.-III main harness A (applicable to vehicles with CAN communication)
  4. M.U.T.-III main harness B (applicable to vehicles without CAN communication)
  5. Measurement adapter
  6. Trigger harness
 MB991824-KIT
NOTE: G: MB991826 M.U.T.-III trigger harness is not necessary when pushing V.C.I. ENTER key.
 CVT check (M.U.T.-III diagnosis code display and service data display)
CAUTION: For vehicles with CAN communication, use the M.U.T.-III main harness A to send the simulated vehicle speed. If you connect the M.U.T.-III main harness B instead, the CAN communication does not function correctly.
G05431331Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 MB992006 Extra fine probe - Continuity check and voltage measurement at harness wire or connector
G05431332Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 MD999576 Transmission range switch adjusting gauge - Transmission range switch adjustment
G05102584Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 MD998330
  1. MD998331

Oil pressure gauge (3.0 MPa)
  1. Joint
 MD998330-01 Hydraulic pressure measurement
G05431334Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 MB992127 Joint MB992018-01
G05093218Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 B991454 Engine hanger balancer MZ203827-01 Engine assembly support during CVT assembly removal and installation {For the engine hanger balancer (MB991454), use chains only.}
NOTE: Engine hanger balancer (MB991454) is a part of the engine hanger assembly (MB991453).
G05102596Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 MB991527 Engine hanger -
G05431337Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 MB991928
Engine hanger
  1. MB991929 Joint (50) x 2
  2. MB991930 Joint (90) x 2
  3. MB991931 Joint (140) x 2
  4. MB991932 Foot (standard) x 4
  5. MB991933 Foot (short) x 2
  6. MB991934 Chain and fork assembly
 Tool not available
G05431338Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 MB991895 Engine mechanical hanger Tool not available
G05425651Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 MB991956
Engine hanger plate		 -
scientia non olet · About LEMON Manuals