LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2008 >> Outlander LS, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (CVT - On-Vehicle Service & Diagnosis) >> On-Vehicle Service >> CVT Control Component Check >> Solenoid Valve Check

Solenoid Valve Check

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the CVT assembly connector.
  2. Measure the resistance between the terminals of the applicable solenoid valves and the earth (terminal No. 19).

    Standard value: 

    RESISTANCE VALUE

    Terminal No. Applicable solenoid valve Resistance value Ω
    1-19 Line pressure solenoid valve Approximately 5.6 to 6.6
    2-19 Secondary pressure solenoid valve
    3-19 Lockup solenoid valve
    4-19 Lockup/select switching solenoid valve Approximately 25.5 to 29.3
    Fig 1: Identifying CVT Assembly Connector
    G05431357Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. When the resistance is within the standard value, check the power supply and the earth circuits.
    CAUTION: Each solenoid valve cannot be removed or replaced as a single unit. When replacement of any one of the solenoid valves is necessary, replace the valve body assembly.
  4. When the resistance is outside the standard value, replace the valve body assembly and the harness.
scientia non olet · About LEMON Manuals