LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2008 >> Outlander LS, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (CVT - On-Vehicle Service & Diagnosis) >> On-Vehicle Service >> CVT Control Component Check >> Paddle Shift Switch Check

Paddle Shift Switch Check

WARNING: This page is about a different variant/trim than selected.
  1. Check that the paddle shift lever is returned to the original position quickly when the lever is released after operation of the paddle shift lever (+/- side) (pulling to the rear side of the vehicle). In addition, check for abnormal looseness, friction and abnormal noise.
  2. Remove the paddle shift assembly. Refer to STEERING COLUMN SHAFT ASSEMBLY .
    Fig 1: Identifying Paddle Shift Lever
    G05431359Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Check the continuity between the paddle shift switch connector terminals.

    Standard value: 

    RESISTANCE VALUE

    Paddle shift lever Terminal number Resistance value
    Upshift and hold the lever. 1-2 Continuity exists (2 Ω or less).
    Downshift and hold the lever. 2-3
    No operation No continuity between the terminals.
  4. In the cases other than the above, replace the paddle shift assembly.
Fig 2: Identifying Paddle Shift Switch Connector Terminals
G05375816Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals