Diagnostic Procedure
WARNING: This page is about a different variant/trim than selected.
- STEP 1. Engine idling speed check
Q: Is the check result normal?
YES : Go to Step 2.
NO : Refer to the "Engine troubleshooting."
- STEP 2. Line pressure check
Carry out "hydraulic test". Refer to HYDRAULIC PRESSURE TEST .
Q: Is the check result normal?
YES : Go to Step 3.
NO : Repair according to the hydraulic pressure test diagnosis table.
- STEP 3. Retest the system.
- Replace TCM.
- Recheck the trouble symptom.
Q: Does the malfunction take place again?
YES : Replace the CVT assembly.
NO : The inspection is complete.